Air Quality Solutions Proposal: AirFinery Impact Analysis

Air Quality Solutions: Final Proposal

Prepared for AdFactor PR | Okhla Phase III

MRH Technologies Pvt. Ltd.

Discussion Agenda

Review of Current Air Quality Challenges (Okhla Phase III)

Demonstration Parameters & Protocol

Performance Data: AirFinery Impact Analysis

Operational Efficiency Findings (Low Mode Results)

Revised Recommendations & Commercial Proposal

The Challenge: High Baseline Pollution

During the measurement period in late December 2025, the Okhla Phase III area experienced severe pollution levels. While inside the untreated premises, AQI reached peaks of 550, and PM10 approached 450. External conditions were even more critical, with AQI topping 750. These levels pose significant health risks and impact workplace productivity.

Demonstration Setup & Protocol

Location: 2nd Floor (11 Plot) - AirFinery Installation Area

Comparative Data: Basement, Reception, First Floor (Untreated)

Measurement Period: Dec 23rd - Dec 29th, 2025

Frequency: Readings taken every 3 hours to ensure consistency

Baseline vs. Treated: AQI Comparison

The AirFinery unit drastically reduced the Air Quality Index (AQI) from a dangerous average of 475 to a safe level of ~49. This represents an 80%+ reduction.

Impact on Particulate Matter (PM2.5)

PM2.5 is the most harmful pollutant to human health. The demo showed a reduction from hazardous levels (Avg 300) to safe limits (Avg 33), even while operating in Low Mode.

A significant reduction of approximately 75% to 85% in AQI, PM2.5, and PM10 levels was observed... achieved while the unit was operating in Low Mode.

Minutes of Meeting: Conclusion (Dec 29, 2025)

The Efficiency Advantage

One of the critical findings was the system's performance at reduced airflow (CFM). Achieving 85% clean air efficiency in 'Low Mode' indicates that the initially projected unit requirements may have been conservative. The AirFinery system has demonstrated reserve capacity, ensuring longevity and lower energy consumption.

Revised Action Plan

Recalculation of total units required based on 'Low Mode' success.

Optimization of coverage zones to maximize cost-efficiency.

Submission of revised commercial recommendation.

Final approval and deployment schedule planning.

Conclusion & Value Proposition

The demonstration at Okhla Phase III has undeniably proven that the AirFinery solution can transform the workplace environment. By effectively reducing pollution by over 75% even at lower power settings, MRH Technologies offers AdFactor PR a solution that is both highly effective and operationally efficient. We are ready to move forward with the installation.