# Electrical Switching Safety: Protocols and PPE Guide
> Essential safety protocols for electrical switching, covering accountability, pre-task assessments (JHA), and mandatory high-voltage PPE requirements.

Tags: electrical-safety, industrial-safety, ppe-requirements, arc-flash, high-voltage, workplace-safety, safety-protocol
## Electrical Switching Safety Procedures
- Introduction to critical protocols for electrical switching including accountability and pre-task assessment.

## Who is Accountable?
- The **Superintendent** is responsible for coordinating the preparation, checking, and execution of switch orders.

## Pre-Task Assessment (JHA)
- **Compliance**: Ensure applicable permits are in place.
- **Review**: Discuss work permit, Isolation Checklist, Switching Order, and SLD (Single Line Diagram).
- **Take 5**: Complete 'Take 5' safety assessment.
- **Walkdown**: Perform a site walkdown to familiarize the team with job scope.
- **Equipment Check**: Verify switching equipment is functionally tested and undamaged.
- **PPE Check**: Ensure Arc Flash and High Voltage PPE are worn and calibrated.

## PPE Required for Switching Activities
- **Hot Gloves**: 26KV - Class 3.
- **Detection**: Hot Stick and High Voltage Detector (clean and inspected).
- **Clothing**: Arc Rating Level 1 (8–12 Cal).
- **Grounding**: Temporary Grounding Jumpers.
- **Lockout**: Lockout Box and Isolation Sheet.
- *Note: All PPE must be approved, calibrated, and properly rated prior to use.*
---
This presentation was created with [Bobr AI](https://bobr.ai) — an AI presentation generator.